AL-1041 SERVICE MANUAL CODE: 00ZAL1041/A1E DIGITAL COPIER AL-10PK AL-11PK AL-1010 AL-1041 MODEL This Srrvice Manual describes only the Printer Interface. For more Information on the AL-1000/1041, please refer to the AL-1000 Service Documentation. CONTENTS [ 1 ] INTRODUCTION ........1 - 1 [ 2 ] MAIN FEATURES .
There- The AL-1000 series copiers are equipped with the printer inter- fore, use the upgrade kit of AL-10PK in this case. For the model face either as standard features or optional features depending which has no memory for SOPM, use the upgrade kit of AL- on the model.
(for IBM PC/AT or compatible computers) ∗ In some models, the memory has been already installed in the machine and is not supplied in the printer upgrade kit (AL-10PK). 2. Removing the cabinet cover and board cover 1) Ensure that the power switch on the copier is in the off posi- tion.
3) Remove the cabinet cover at the slit portion by bending it back with your hand to separate it. Take care in handling the cabinet cover because the ex- posed edge could be sharp and may injure your hands.
AL-1041 4) Fit the projections of the cabinet to the notches of the 3) Plug the other end of the cable into the parallel interface machine, push the cabinet downward a little and then slide connector on your computer. (Refer to your computer it in the direction indicated by the arrow.
AL-1041 A. Windows 95/Windows NT 4.0: INSTALLING THE PRINTER DRIVER 1) Load paper into the paper tray of the printer. SOFTWARE 2) Turn on the printer. 1. Description of the printer driver The printer driver is the software program which runs the 3) Turn on your computer and start Windows.
Next button. To select a different folder, select Browse and type in the new path 7) Windows driver file search will find the device SHARP AL- and folder name. Click OK and say YES to create the 1000 Series.
DATA3 GND (DATA3 RET) 4. AL-1000 Series printer driver group DATA4 GND (DATA4 RET) When the printer driver is installed, the SHARP AL-1000 Series DATA5 GND (DATA5 RET) printer driver group will be created. This group allows the fol- DATA6 GND (DATA6 RET) lowing functions to be executed.