Sharp AL-1000 Series Operation Manual page 28

Message
Paper Jam
Check Paper Tray : Out of Paper
or Misfeed
Check Bypass Tray : Out of
Paper or Misfeed
Service Error
Switch Main Power OFF on the
product. Wait approximately 5
seconds. Switch Main Power
ON. If the Service Error
continues, Contact your
authorized SHARP Service
Center.
Product Communication Error
The computer has lost
communications with the
product. Cancel the current
operation, turn the product off
then back on, retry the
operation.
*2: See the section on TD CARTRIDGE REPLACEMENT.
*3: See the section on DRUM CARTRIDGE REPLACEMENT.
*4: See the section on INSTALLING THE TD CARTRIDGE.
*5: See the section on MISFEED REMOVAL.
*6: See the section on LOADING COPY PAPER.
*7: See the section on BYPASS FEED.
Solution
A piece of paper has misfed within the printer.
Printing cannot continue until the misfed
paper is removed.
The paper tray is out of paper or the paper did
not feed correctly. Printing cannot continue
until you load the paper or clear the misfeed in
the paper tray.
The bypass tray is out of paper or the paper
did not feed correctly. Printing cannot continue
until you load the paper or clear the misfeed in
the bypass tray.(Multi-sheet Bypass Machines
only)
The product has detected a fatal error
condition and cannot continue. Make a note
of any specific error conditions or codes.
Then turn the product's main power switch to
OFF. Wait for five seconds. Then turn the
product's main power switch to ON. If the
product error condition persists, please
contact your authorized SHARP Service
Center.
The computer has lost communications with
the product. Cancel the current operation.
Then turn the product's main power switch to
OFF. Check the cable connections carefully.
Wait five seconds, Then turn the product's
main power switch to ON. Try the print job
again. If the product communications error
condition persists, please refer to the
Operation manual.
STATUS MONITOR
See
page:
5
Copier*
6
Copier*
7
Copier*
–
9
27
3