Installation (Scsi File Devices) - NEC Express5800/120Ri-2 User Manual

9-60 Upgrading Your Server

Installation (SCSI File Devices)

1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Remove the drive cover and logic cover.
4.
Remove the PCI riser module assembly (see "PCI board" described earlier in this chapter).
5.
Remove the support arm and processor duct (see "CPU" described earlier in this chapter).
6.
While pulling the lever toward the right side of the server, pull the DVD-ROM drive out
of the chassis.
IMPORTANT:
removing the DVD-ROM drive. Otherwise, your fingers may be
caught.
7.
While pushing the latching tab that secures the device bay, push the device carrier out of
front of the server.
IMPORTANT:
excess force. If the tab bends, straighten it out as it was.
Do not touch any other part than release lever when
Be careful not to bend the latching tab by applying