NEC Express5800/120Ri-2 User Manual page 113

Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
Make sure to complete board installation.
Do not install the server on a rack with leaving covers removed.
Do not pinch your finger with mechanical components.
Note high temperature.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
1.
See the section "Preparing for Installation and Removal" as described in Chapter 9 of this
guide to prepare.
2.
Remove the logic cover (see Chapter 9).
3.
Locate the position of the RAID configuration jumper on the mother board as shown
below.
Front
4.
Remove the jumper from position 1 – 1 on jumper block.
5.
Reinstall the jumper on position 2 – 3 on jumper block.
6.
Reinstall the server removed in Step 2.
7.
Plug the power cord to your server and turn on the server.
CAUTION
RAID configuration
jumper
RAID RAID
disable disabl
Configuring Your Server 4-23
RAID
enable
Rear