NEC Express5800/120Ri-2 User Manual page 199

8-6 Troubleshooting
Error
Error message
code
0B8F Could not redirect the console - BMC
Parameter Error -
0B90 BMC Platform Information Area corrupted.
0B91 BMC update firmware corrupted.
0B92 Internal Use Area of BMC FRU corrupted.
0B93 BMC SDR Repository empty.
0B94 IPMB signal lines do not respond.
0B95 BMC FRU device failure.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
0B9A Management controller not responding.
0B9B Private I2C bus not responding.
0B9C BMC internal exception.
0B9D BMC A/D timeout error.
0B9E SDR repository corrupt.
0B9F SEL corrupt.
0BB0 SMBIOS – SROM data read error.
0BB1 SMBIOS – SROM data checksum bad.
8100 Memory Error detected in DIMM group #1.
8101 Memory Error detected in DIMM group #2.
8102 Memory Error detected in DIMM group #3.
8103 Memory Error detected in DIMM group #4.
8104 Memory Error detected in DIMM group #5.
8105 Memory Error detected in DIMM group #6.
8160 Mismatch Processor speed detected on
Processor 1.
8161 Mismatch Processor speed detected on
Processor 2.
Recommended Action
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
Turn off the power once and then on again
to restart the server. If the error cannot be
corrected, contact your service
representative.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
This is not a fatal error. Turn off the power
once and then on again to restart the
server. If the error cannot be corrected,
contact your service representative.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
Update the RMC firmware. If the error
cannot be corrected, contact your service
representative.
Turn off the power once and then on again
to start the server. If the error cannot be
corrected, contact your service
representative.
Contact your service representative.
Contact your service representative to
replace the DIMM in the relevant group.
Contact your service representative.