Other Depth And Speed/Temperature Transducers; Fuel Transducers; Mounting The Fish450 Tricolor Display Unit - Navman FISH 450 Tricolor Installation And Operation Manual

5-4 Other depth and speed / temperature transducers
Correct transducer installation is critical to the
performance of the unit. Most transducers come
with instruction. It is important to carefully read and
follow the instructions provided.
NAVMAN through-hull transducers and speed/

5-5 Fuel transducers

Fuel transducers
A single or twin engine fuel kit can be purchased
separately. It is supplied with the "NAVMAN Fuel
flow transducer installation instructions". This
transducer is for use with petrol engines only.
A fuel filter must be placed on the fuel line between

5-6 Mounting the FISH450 Tricolor display unit

Mounting the bracket
1. Select a position where the display head will
be:
• At least 300mm away from the compass.
• At least 300mm away from any radio
transmitter.
• At least 1.2 metres away from the VHF
antenna.
• Easy to read by the helmsman and crew
while underway. Colours are best when
viewed from directly in front of the unit.
• Protected from physical damage during
rough sea passages.
• Easy to access the 12 volt power source.
• Convenient to route the transducer cables.
2. Remove the round base from the centre of the
bracket.
3. Affix the round base using the 4 stainless screws
provided.
4. Orientate the bracket on the round base and
screw down the central locking knob.
Note: There is also a flush mount kit available.
Please consult your NAVMAN dealer.
20
temperature transducers are available for the
FISH450 Tricolor. These are separate transducers
which require separate mounting.
Please consult your NAVMAN dealer when
attempting to install other transducers.
the transducer and the fuel tank.
When the installation is complete, please follow the
instructions in Setup Fuel section 4-2.
Note: Before the fuel features can be used they
must be enabled by setting Num Engines to either
1 or 2.
Mounting the FISH450 Tricolor
1. Attach cables.
2. Slide mounting screws into the slots on the
mounting bracket. The rubber washers go between
the body of the fishfinder and the mounting bracket.
Removing the FISH450 Tricolor
You may remove your fishfinder after each use for
protection against the environment or security
reasons.
If you do remove the FISH450 Tricolor, ensure that
the plugs left in the boat are not exposed to the
elements. Keep the unit in a dry clean place.
NAVMAN
FISH450 Tricolor FISHFINDER Installation and Operation Manual