Ricoh 4051 Operating Instructions Manual page 108

Troubleshooting
Machine Status
Misfeeds occur frequently.
An error message remains,
even after the misfed paper
5
is removed.
Cannot duplex print
During saddle stitching,
paper comes out open and
not neatly stacked.
The user code entry dis-
play appears.
The Authentication screen
appears.
"
You do not have
the privilegesto
use the following
function(s).
played.
"
You do not have
the privilegesto
use the following
function(s).
ues to be displayed even
though you have entered a
valid user code.
96
Problem/Cause
The side guides of the pa-
per tray may not be locked.
The end guide of the paper
tray may not be locked.
You may have loaded pa-
per whose size cannot be
detected automatically.
The saddle stitching staple
cartridge for the Booklet
Finisher has been removed.
When a misfeed message
appears, it remains until
you open and close the cov-
er, as required.
You cannot use the paper
in the bypass tray for du-
plex printing.
The setting for the Paper
Type: Tray 1-3 is "1 Side
Copy".
Depending on the type of
paper, the paper may
spring open after it is fold-
ed.
Users are restricted by user
codes.
Basic Authentication, Win-
dows Authentication, or
LDAP Authentication is
set.
The use of the function is
restricted to authenticated
users only.
" is dis-
This user code is not al-
lowed to use the function
selected.
" contin-
Action
Check the side guides are locked.
See p.115 "Changing the Paper
Size".
Check that the end guide is locked.
See p.115 "Changing the Paper
Size".
When you use paper of a size that
cannot be detected automatically,
set the paper size. See p.58 "Tray Pa-
per Size: (Tray 2,3)", p.155 "Copy
Paper".
Reset the saddle stitching staple car-
tridge. See p.117 "d Adding Sta-
ples".
Clear misfed paper and open and
close the front cover. ⇒ p.105 "x
Clearing Misfeeds"
For duplex printing, select Tray 1-3
in Copier mode or with the printer
driver.
Select "2 Sided Copy" for Paper
Type: Tray 1-3. See p.58 "Paper
Type: (Tray1-3, LCT)".
Select a paper type that does not
spring back easily .
Enter the user code (up to 8-digits),
and then press [#].
Enter your login user name and user
password. See p.25 "When the Au-
thentication Screen is displayed".
Contact the administrator.
Press the { { { { Energy Saver} } } } key. Con-
firm that the display goes off, and
then press the { { { { Energy Saver} } } } key
again. The display will return to the
user code entry display.