Boil-Out Procedure - Dean SM35 Installation & Operation Manual

DEAN MILLIVOLT SERIES GAS FRYERS (NON-CE)

4.2 Boil-Out Procedure

Never leave the fryer unattended during the boil-out process. If the boil-out solution
boils over, turn the fryer off immediately and let the solution cool for a few minutes
before resuming the process. To lessen the chance of boil over, turn the fryer's gas
Do not drain boil-out solution into a shortening disposal unit, a built-in filtration unit,
or a portable filter unit. These units are not intended for this purpose, and will be
Remove all drops of water from the frypot before filling with cooking oil or
shortening. Failure to do so will cause spattering of hot liquid when the oil or
shortening is heated to cooking temperature and may cause injury to nearby
4.2.1 Thermostat-Equipped Fryers
A. Pour cleaning solution into the frypot and add water to the bottom OIL LEVEL line scribed
in the back of the frypot.
B. Set the operating thermostat dial/temperature controller to 225°F (107ºC), just above that of
boiling water.
C. The main burner will ignite.
D. When the solution nears boiling point, reset the temperature controller to 200°(93ºC).
E. The burners should shut off just as the water starts to boil.
F. The burners will heat the boil-out solution to a simmer.
approximately 45 minutes. Wearing protective gloves, scrub the sides of the frypot and the
tubes with the L-shaped Teflon brush, being careful not to disturb the temperature sensing
probes and the high-limit thermostat.
G. Do not allow the water level to decrease below the bottom OIL LEVEL line in frypot during
boil-out operation.
CHAPTER 4: FRYER OPERATIONS
valve knob to the PILOT position occasionally.
damaged by the solution.
personnel.
DANGER
WARNING
DANGER
4-3
Simmer the solution for