Frymaster 8195916 User Manual page 5

e. , indicating a heating problem. Turn the fryer off and call the Frymaster hotline.
f. , indicating the frypot temperature is in excess of 410ºF (210ºC). If this appears in the
display, turn the fryer off immediately! NOTE: In computers used in the European Union
(those with the CE mark), the temperature is 395°F (202°C).
g. , indicating that the computer has detected a problem in the temperature measuring
and control circuits. Turn the fryer off and contact an authorized servicer.
2. When appears in the displays, press a product switch to initiate a cook cycle.
a. The display will indicate the programmed cook time and begin to count down. On fryers
equipped with basket lifts, the product basket will be lowered into the frypot.
b. If a shake time is programmed, an alarm will sound at the specified time and the display will
read SH#, where "#" will be the button number. The alarm will sound for 3 seconds then self-
cancel. If no shake time has been programmed, sh# will not appear during the cook cycle.
c. At the end of the cooking cycle, an audible alarm will sound, cooc will be displayed, and the
associated product button indicator will flash. To cancel the cook alarm, press the flashing
button. On fryers equipped with basket lifts, the product basket will be raised from the
frypot.
d. At this time, the hold time will be displayed (if programmed greater than zero), and the
countdown will begin. When the countdown reaches zero, hD# will be displayed (where # is
the button number) and an alarm will sound. The hold alarm is canceled by pressing the
Programming Switch
be displayed.
3. To check the frypot temperature at any time, press the Temperature Check Switch
check the setpoint, press the switch twice. If you suspect the temperature is incorrect, check the
temperature of the frypot with a thermometer or pyrometer to verify that the computer readout is
reasonably close to the measured reading. If it is not, contact a factory authorized service center
for assistance.
4. On full-pot fryers, during idle periods,
fryers, should appear only on the side that is turned on. If not, check the actual
temperature and setpoint.
The electronic circuitry in your computer can be affected adversely by current
fluctuations and electrical storms. Should it fail to function or program properly for
no apparent reason, the computer should be reset by unplugging the computer and
plugging it back in. This could prevent a service call.
. NOTE: If the display is in use, the hold time countdown will not
should appear in both displays. On split-pot
CAUTION
1 - 3
once. To