Loading Paper In Tray 5 (Bypass) - Xerox 4110 Getting Started

3. L o ad i ng pa pe r

Loading paper in tray 5 (Bypass)

3- 4
5. Move the two paper guide levers until they just touch the
edges of the paper.
a. Ensure that the paper guides fit correctly into the slots on
the tray and release the levers.
b. Ensure that the paper guides are adjusted to the same
size as the paper in the tray.
KEY POINT: Do not load paper above the MAX line.
6. Gently push the tray in until it stops.
If you print to a paper size that is different from the paper loaded in
trays 1 through 4, use Tray 5, the Bypass, for your print job.
Use the following procedure for loading paper in Tray 5 (Bypass).
1. Open Tray 5.
NOTE: If necessary, pull out the extension part of the tray.
2. Hold the center of the paper guides and slide the guides to the
desired paper size.
X er ox 4 59 0 E P S / 4110 E P S G e tt i ng Sta r te d