Motorola Netopia 2200 Administrator's Handbook page 78

Administrator's Handbook
Displayed port interfaces vary depending on the kinds of physical ports on your Gateway, for exam-
ple, Ethernet.
For Motorola Netopia
may be configured.
To enable any of them on this VLAN, check the associated Enable checkbox(es).
Typically you will choose a physical port, such as an Ethernet port (example: eth0.1).
◆
When you enable an interface, the Tag, Priority, and Promote checkboxes, and the 802.1p Priority
Bit menu appear for that interface.
Tag – Packets transmitted from this port through this VLAN must be tagged with the VLAN VID. Pack-
ets received through this port destined for this VLAN must be tagged with the VLAN VID by the
source. The Tag option is only available on global type ports.
Priority – Use any 802.1p priority bits in the VLAN header to prioritize packets within the Gateway's
internal queues, according to DiffServ priority mapping rules.
Promote – When checked, this port writes any specified 802.1p priority bits
TOS header bit field for IP packets received on this port, destined for this particular VLAN. It writes
any specified IP-TOS priority bits into the 802.1p priority bit field for tagged IP packets transmitted
from this port for this VLAN.
All mappings between Ethernet 802.1p and IP-TOS are made according to a pre-defined QoS map-
ping policy. The pre-defined mapping can now be set in the CLI. See
page 172.
802.1p Priority Bit – If you select a value greater than 0, all packets received on this port with
unmarked priority bits will be re-marked to this priority. If the port 802.1p PBit is greater than 0, the
VLAN 802.1p PBit setting is ignored.
◆
Select an IP Interface for this VLAN if it is to be routed; otherwise leave the default. These selec-
tions will vary depending on your IP interfaces. For example, if you have set up multiple VCCs, these
will appear in the list as ip-vcc1, ip-vcc2, and so forth.
◆
When you select an IP interface, the screen expands to allow you to configure Inter-Vlan-Groups.
Inter-VLAN groups allow VLANs in the group to route traffic to the others; ungrouped VLANs cannot
route traffic to each other.
78
®
VGx technology models, separate Ethernet switch ports are displayed and
(page 77) into the IP-
"Queue Configuration" on