Ethernet Port Settings - Motorola Netopia 2200 Administrator's Handbook

Motorola router administrator’s handbook
Hide thumbs Also See for Netopia 2200:
Table of Contents

Advertisement

Administrator's Handbook
ADSL platforms
You must configure two VCCs with the same VPI/VCI to enable concurrent PPPoE and IPoE support, and
you will need to configure the individual settings for each interface for proper operation.
set atm vcc n encap pppoe-llc
Specifies that the VCC will allow a second VCC with the same VPI/VCI values as the first. pppoe-llc
denotes this special case.
Example:
set atm option on
set atm vcc 1 option on
set atm vcc 1 vpi 0
set atm vcc 1 vci 35
set atm vcc 1 encap pppoe-llc
set atm vcc 2 option on
set atm vcc 2 vpi 0
set atm vcc 2 vci 35
set atm vcc 2 encap ether-llc
This will allow you to configure the second WAN interface.
set atm vcc 2 vpi 0
set atm vcc 2 vci 35
set atm vcc 2 encap ether-llc
...
set ip ip-ppp vcc1 mcast-fwd [ on | off }
Enables or disables multi-cast forwarding on the specified interface. If set to on, this interface acts as
an IGMP proxy host, and IGMP packets are transmitted and received on this interface on behalf of
IGMP hosts on the LAN interface. See
set ip ip-ppp vcc1 igmp-null-source-addr [ off | on ]
Enables or disables IGMP null source address, if mcast-fwd is set to on. If enabled, the source IP
address of every IGMP packet transmitted from this interface is set to 0.0.0.0. This complies with the
requirements of TR-101, and removes the need for a publicly advertised IP address on the WAN inter-
face.

Ethernet Port Settings

set ethernet ethernet A mode { auto | 100M-full | 100M-full-fixed |
100M-half-fixed | 10M-full-fixed | 10M-half-fixed |
100M-half | 10M-full | 10M-half }
Allows mode setting for the ethernet port. Only supported on units without a LAN switch, or dual ether-
net products (338x). In the dual ethernet case, "ethernet B" would be specified for the WAN port. The
default is auto.
184
"IGMP Settings" on page 158
for more information.

Advertisement

Table of Contents
loading

Table of Contents