Reset Wan - Motorola Netopia 2200 Administrator's Handbook

Administrator's Handbook
This command is only for the 3342N/3352N. If the Gateway is not a 3342N/3352N this command
does nothing but returns the message: "CD mode is not supported on this platform."
reset crash
Clears crash-dump information, which identifies the contents of the Motorola Netopia® Gateway regis-
ters at the point of system malfunction.
reset dhcp server
Clears the DHCP lease table in the Motorola Netopia® Gateway.
reset diffserv
Resets the Differentiated Services (diffserv) statistics.
reset enet [ all ]
Resets Ethernet statistics to zero. Resets individual LAN switch port statistics as well as wireless and
WAN Ethernet statistics (where applicable).
reset heartbeat
Restarts the heartbeat sequence.
reset ipmap
Clears the IPMap table (NAT).
reset log
Rewinds the diagnostic log display to the top of the existing Motorola Netopia® Gateway diagnostic log.
The reset log command does not clear the diagnostic log. The next show log command will display
information from the beginning of the log file.
reset security-log
Clears the security monitoring log to make room to capture new entries.
reset wan-users [all | ip-address ]
This function disconnects the specified WAN User to allow for other users to access the WAN. This func-
tion is only available if the number of WAN Users is restricted and NAT is on. Use the all parameter to
disconnect all users. If you logon as Admin you can disconnect any or all users. If you logon as User,
you can only disconnect yourself.

reset wan

This function resets WAN interface statistics.
132