Expansion Slots; Installing An Expansion Card; Configuring An Expansion Card - AMD GEODE NX800LX User Manual

1.4 Expansion Slots

In the future, you may need to install expansion cards. The following sub‑sections describe
the slots and the expansion cards that they support.
1.4.1

Installing an Expansion Card

1. Before installing the expansion card, read the documentation that came with it and
make the necessary hardware settings for the card.
2. Remove the system unit cover (if your motherboard is already installed in a chassis).
3. Remove the bracket opposite the slot that you intend to use. Keep the screw for later
use.
4. Align the card connector with the slot and press firmly until the card is completely
seated on the slot.
5. Secure the card to the chassis with the screw you removed earlier.
6. Replace the system cover.
1.4.2

Configuring an Expansion Card

After installing the expansion card, configure it by adjusting the software settings.
1. Turn on the system and change the necessary BIOS settings.
2. Assign an IRQ to the card if needed.
3. Install the software drivers for the expansion card.
Make sure to unplug the power cord before adding or removing
expansion cards. Failure to do so may cause you physical injury and
damage motherboard components.
User's Manual
NX800LX 17