Refitting A Normal Wheel - Alfa Romeo 147 Owner's Manual

– Completely unscrew the fastening bolts
and remove the wheel.
– Make sure that the contact surfaces of
the spare wheel with the hub are clean
and free of impurities which may later cause
the fastening bolts to slacken.
– Install the spare wheel matching the
hole (A-fig. 7) with the corresponding
pin (B).
– Using the wrench provided, fasten the
five bolts.
– Lower the car and remove the jack.
– Using the wrench provided, fully tighten
the bolts in the sequence shown in fig. 8.
202
fig. 5
REFITTING A
NORMAL WHEEL
– Following the procedure described pre-
viously, raise the car and remove the spare
wheel.
For versions with steel rims:
– Fit the normal wheel matching the
hole (A-fig. 7) with the corresponding
pin (B).
– Make sure that the contact surfaces of
the wheel with the hub are clean and free
of impurities which may later cause the fas-
tening bolts to slacken.
– Using the wrench provided, tighten the
fastening bolts.
A0A0152m
fig. 6
– Lower the car and remove the jack.
– Using the wrench provided, fully tight-
en the bolts in the sequence shown previ-
ously for the compact spare wheel fig. 8.
– Place the cap near the wheel so that
the inflation valve can come through the
slot provided on the cap.
– Press the circumference of the cap,
starting from the parts nearest to the infla-
tion valve until it is inserted completely.
IMPORTANT Incorrect fitting may
cause the wheel cap to come off when the
car is travelling
A0A1140m