Refitting A Normal Wheel - Alfa Romeo Brera Owner's Manual

fig. 8
❒ fit the space-saver spare wheel mak-
ing one of the holes A-fig. 8 co-
incide with the relevant pin B;
❒ Using the wrench provided, fully
tighten the five fastening bolts;
❒ Lower the car and remove the jack;
❒ Use the wrench provided to fasten
the bolts completely in a criss-cross
fashion according to the sequence
shown in fig. 9.
A0F0209m
fig. 9
REFITTING A NORMAL
WHEEL
Following the procedure described pre-
viously, raise the car and remove the
spare wheel.
Proceed as follows:
❒ tighten pin A-fig. 10 in one of the
holes of the wheel hub fastening
bolts;
❒ insert the wheel on the pin and, us-
ing the wrench provided, tighten the
four bolts available;
A0F0210m
fig. 10
❒ loosen pin A-fig. 10 and tighten
the last fastening bolt;
❒ lower the car and remove the jack,
then, using the wrench provided tight-
en the bolts according to the se-
quence previously shown for the
space-saver spare wheel fig. 9.
A0F0211m
175