Table of Contents
Advertisement
STARTING THE ENGINE — GAS
Before starting your vehicle, adjust your seat, adjust
both inside and outside mirrors, and fasten your seat
belts.
WARNING!
•
When exiting the vehicle, always remove the key
fob from the vehicle and lock your vehicle.
•
Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
•
Allowing children to be in a vehicle unattended is
dangerous for a number of reasons. A child or oth-
ers could be seriously or fatally injured. Children
should be warned not to touch the parking brake,
brake pedal or the transmission gear selector.
•
Do not leave the key fob in or near the vehicle, or
in a location accessible to children, and do not
leave the ignition of a vehicle equipped with Key-
less Enter 'n Go™ in the ON/RUN position. A child
could operate power windows, other controls, or
move the vehicle.
•
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat buildup may
cause serious injury or death.
Start the engine with the gear selector in the NEUTRAL
or PARK position. Apply the brake before shifting to any
driving range.
STARTING AND OPERATING
NORMAL STARTING
Place the ignition switch in the START position and
release when the engine starts. If the engine fails to
start within 10 seconds, place the ignition switch in the
OFF position, wait 10 to 15 seconds, then repeat the
"Normal Starting" procedure.
Tip Start Feature
Place the ignition switch in the START position and
release it as soon as the starter engages. The starter
motor will continue to run, and will automatically disen-
gage itself when the engine is running. If the engine
fails to start, place the ignition switch in the OFF posi-
tion, wait 10 to 15 seconds, then repeat the "Normal
Starting" procedure.
Automatic Transmission
The gear selector must be in the NEUTRAL or PARK
position before you can start the engine. Apply the
brakes before shifting into any driving gear.
Damage to the transmission may occur if the follow-
ing precautions are not observed:
•
Do not shift between PARK, REVERSE, NEUTRAL,
or DRIVE when the engine is above idle speed.
•
Shift into or out of PARK or REVERSE only after the
vehicle has come to a complete stop.
•
Before shifting into any gear, make sure your foot
is firmly on the brake pedal.
CAUTION!
Keyless Enter 'n Go™ Functions — Using The ENGINE
START/STOP Button
1. The transmission must be in PARK or NEUTRAL.
2. Press and hold the brake pedal while pushing the
ENGINE START/STOP button once.
3. The system starts the vehicle. If the vehicle fails to
start, the starter will disengage automatically after
10 seconds.
4. If you wish to stop the cranking of the engine prior to
the engine starting, push the ENGINE START/STOP
button again.
Keyless Enter 'n Go™ — With Driver's Foot Off The
Brake Pedal (In PARK Or NEUTRAL Position)
The Keyless Enter 'n Go™ feature operates similar to an
ignition switch. It has three positions, OFF, ON/RUN,
and START. To change the ignition switch positions with-
out starting the vehicle and use the accessories follow,
these steps starting with the ignition switch in the OFF
position:
1. Push the ENGINE START/STOP button once to
change the ignition switch to the ON/RUN position.
2. Push the ENGINE START/STOP button a second time
to change the ignition switch to the OFF position.
95
4
Advertisement
Table of Contents
