4-4 Windows NT4
Installing Drivers During Windows NT 4.0 Installation
1.
Start the system installation by booting from the Windows NT disk:
a) Floppy install: boot the system with the Windows NT installation diskettes.
b) Floppyless install: boot from floppy and type "WINNT /B". After files have been
copied, the system will reboot. On the reboot, press the "F6" key when the
message "Setup is inspecting your computer's hardware configuration..."
appears.
c) CD-ROM disk install: boot from the CD-ROM disk and press the "F6" key when
the message "Setup is inspecting your computer's hardware configuration..."
appears.
2. When the "Windows NT Setup" window is generated, press "S" to Specify an
Additional Device(s).
3. Press "O" to select "Other" and press the "Enter" key.
4.
Insert the RAID Function driver diskette into drive A: and press the "Enter" key.
5. Choose "Win NT Promise MBFastTrak133 Lite (tm) Controller" from the list that
appears on screen, then press the "Enter" key.
6. The Windows NT Setup screen will appear again saying "Setup will load support
for the following mass storage devices:" The list will include "Win NT Promise
MBFastTrak133 Lite (tm) controller".
NOTE: If you need to specify any additional devices to be installed, do so at this time.
Once all devices are specified, continue to step 7.
7. From the Windows NT Setup screen, press the Enter key. Setup will now load all
device files and then continue the Windows NT installation.
8. After a successful installation, the "SCSI Adapter Setup" box will show that the
"Win NT Promise MBFastTrak133 Lite (tm) Controller" driver has been installed..
2 7
Installing Driver
Need help?
Do you have a question about the Promise RAID Function and is the answer not in the manual?