Troubleshooting - Epson STYLUS PRO 9000 User Manual

o= On, f= Flashing, n= Off
Message and Light
LOAD ROLL PAPER
LOAD SHEET PAPER
oPaper Out
PAPER JAM
fPaper Out
COVER OPEN
PAPER NOT CUT
fPaper Out
PAPER NOT
STRAIGHT
fPaper Out
RELOAD PAPER
fPaper Out
Problem
The paper source
setting in the printer
driver is different from
the control panel.
Paper is jammed in
the printer.
Lower cover is open.
Roll paper was not
cut.
Cut paper did not fall
off.
Slippage occurred
and paper was fed at
an angle.
Paper could not be
reversed into the
printing position.
Paper is set out of the
printable area.
Paper is set out of the
horizontal cutting
area.
Paper is not fully
ejected.
PAPER NOT CUT error
was cleared.
Solution
Make sure the paper
source setting in the
printer driver is the same
as the control panel.
Remove the jammed
paper. See also "Paper
Feed or Paper Jam
Problems Occur
Frequently" on page
136.
Close the lower cover.
Cut the paper manually,
then remove the cut
paper from the printer.
When RELOAD PAPER is
displayed, load paper.
Remove the cut paper
from the printer. When
RELOAD PAPER is
displayed, load paper.
Reload paper. See
"Paper Feed or Paper
Jam Problems Occur
Frequently" on page
136.
Remove then reload the
paper so that the right
and bottom edges are
straight and in line with
the rows of punch holes
on the printer. See
Chapter 4, "Paper
Handling".
Cut the paper at the
paper insertion slot, then
reload paper.
Reload paper.

Troubleshooting

123