Starting - NEC Express 5800/120Eh N8100 SERIES User Manual

6-10 Installing and Using Utilities

Starting

The following two methods are available to start the server.
Running NEC EXPRESSBUILDER from the management PC via LAN
Running NEC EXPRESSBUILDER from the management PC via direct connection
(COM B)
For the procedure for starting NEC EXPRESSBUILDER for DOS-based with Remote Console, see
"NEC DianaScope".
IMPORTANT:
Do not change the boot device order in BOOT menu in BIOS
SETUP. NEC EXPRESSBUILDER cannot be used if the DVD-
ROM drive is not the first device to launch the system.
To use the remote console feature, a floppy disk containing a
configuration information file must be inserted in the floppy disk
drive. You can create a configuration information file by using
System Management feature in the Tools menu or by NEC
DianaScope Configuration menu. The configuration information
file must be named as "CSL_LESS.CFG" and stored in the root
directory of the floppy disk.
NOTE: The following items of BIOS setup information will be set as
shown below.
LAN Controller:
Serial Port A:
Base I/O Address:
Interrupt:
Serial Port B:
Base I/O Address:
Interrupt:
BIOS Redirection Port:
Baud Rate:
Flow Control:
Console Type:
[Enabled]
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[2F8]
[IRQ 3]
[Serial B]
[19.2K]
[CTS/RTS]
[PC ANSI]