Configuring Mother Board Jumpers - NEC Express 5800/120Eh N8100 SERIES User Manual

CONFIGURING MOTHER BOARD JUMPERS

You can use the following procedure to clear the CMOS data in the server.
IMPORTANT:
Clearing the CMOS data resumes the factory-set configuration data.
Do not change any other switch settings. Any change may cause the
server to fail or malfunction.
Clearing CMOS sets [SATA RAID Enabled] in the [Advanced] -
[Peripheral Configuration] menu to [Disabled]. If the SATA hard
disk drives are installed in your server and the onboard SATA
RAID feature is used, change the parameter of the [SATA RAID
Enabled] from [Disabled] to [Enabled] before exiting BIOS Setup.
Leaving this parameter as the factory-set value (Disabled) may
destroy the data in hard disk drive.
NOTE:
[Advanced] - [Peripheral Configuration] - [SATA Controller Mode
Option] - [Enhanced].
To display the [SATA RAID Enabled] menu, select
Clear
Protect
Configuring Your Server 4-45
Mother board