NEC Express 5800/120Eh N8100 SERIES User Manual page 264

9-58 Upgrading Your Server
13.
Connect the SATA cable provided with the HDD cage, I2C cable, and power cable as
shown in the figure below.
Power cable
(4-pin connector)
I2C cable
(4-pin connector)
14.
Connect the SATA cable to the RAID board (SATA).
A label indicating a channel number of destination port is attached to SATA cable.
Connect the SATA cable to the port (connector) having the same number as that of SATA
cable.
NOTE:
N8103-101 RAID board. The location of connector and assignment of
channel numbers depend on the board. Refer to the manual that comes
with your board.
The figure below shows an example when connecting to
SATA cable