Ring Allocation For The Door Interphone - Gigaset 1054 Operating Instructions Manual

1054K07C.FM
28.10.96
Operation with Comfort Mobile Unit
Set / Change the Number of Rings for Group Call
By selecting the number of rings, you can stipulate the number of tone rings which are signalled
at call group 1 before the call is diverted to call group 2.
After choosing "External 1/2" (see previous
External 1/2
page), the menu shown here appears:
Scroll, using NEXT...
until "No. of ring cycles" appears in the 1st
No.of ring cycles
line; then select with OK.
Push OK if you only want to view
or
Push the digit key to enter the number of
1...9
rings; here, 5.
SAVE
Push this key to save the entry.

Ring Allocation for the Door Interphone

You can stipulate which internal stations are to be signalled by the door interphone. These inter-
nal stations can also then open the door.
1. In idle status, push the ß
2. In the Service menu, select "System settings" and enter the system code
(see page 115).
After the correct system code is entered,
the following menu appears:
Scroll through the menu with NEXT ...
After selecting "a/b line" from the "Equip-
a/b line
ment data" menu ,
scroll with NEXT...
until "a/b line 9" is on the 1st line; then sel-
a/b line 9
ect with OK.
Scroll with NEXT ...
until "New: doorstation" is on the 1st line;
New:doorstation
select with OK.
The following list appears; enter station 1
and 2 here.
OK
Push this if you only want to view
or
0 ...8
Enter one-digit internal number; here, 4;
if necessary, correct with
SAVE
Push this key to save the list.
120
Gigaset 1054, GBR: A30852-X954-B101-1-7619
key and select "Service" from the main menu.
System Settings
Ring Allocation
No. of cycles
Pause ring end
NEXT
Set number of
ring cycles
3
Set number of
ring cycles
5
Duration/Units
Tel. no. lock
Change Sys.code
NEXT
a/b line 0
a/b line 9
Internal 1
NEXT
Active: Telephone
New: Doorstation
New: Modem
NEXT
Door call to
1 2
Door call to
1 2 4
.
OK
OK
Save
OK
OK
OK
OK
SAVE