Set The Cos For Internal Stations - Gigaset 1054 Operating Instructions Manual

1054K07B.FM
28.10.96
Operation with Comfort Mobile Unit

Set the COS for Internal Stations

By setting the Class of Service for every registered mobile unit, you can stipulate which internal
stations can place external toll calls.
At the time of initialization, all devices are fully trunk authorized.
1. Full Trunk Authorization (= status at initialization)
Incoming and outgoing external calls are permissible.
2. Incoming Authorization
It is only possible to accept incoming calls. All external dialing is blocked.
3. Internal Authorization
Only internal calls are possible. All external dialing is blocked. You can initiate a consultation
call to an authorized internal station, but cannot transfer an external call; you will receive a
callback in that case.
1. In idle status, push the ß
2. In the Service menu, select "System settings" and enter the system code
(see also page 115).
After the correct system code is entered,
the following display appears:
Scroll through the menu with NEXT ...
until "Equipment data" is on the 1st line;
Equipment data
then select with OK.
Scroll through the menu with NEXT ...
Access rights until "Access rights" is on the 1st line; then
select with OK.
Using NEXT, find the internal stations for
which the access rights are to be set and
select them with OK; here, internal station
0.
Internal X
You can now stipulate the COS.
Note:
If your Gigaset 1054 is being operated on only one telephone line, then you should set
"Internal authorization" for the 2nd telephone line.
Gigaset 1054, GBR: A30852-X954-B101-1-7619
key and select "Service" from the main menu.
Lock
Sys cd/Mn sys cd
Duration/Units
Call barring
NEXT OK
Autom. seizure
Call pickup
Access rights
NEXT OK
Internal 0
Internal 1
Internal 2
NEXT OK
Active: trunk acc.
incoming
New:
New: internal
NEXT OK
113