Table of Contents
Advertisement
Changing the meter size of the detector
The following is an example to change the meter size from 50mm to 10mm.
Switch operation
A2: METER SIZE
A2: METER SIZE
A2: METER SIZE
A2: METER SIZE
A2: METER SIZE
Note 1: The meter size is displayed cyclically as shown below:
2.5mm
0.1inch
* For partially filled pipes detectors (LF232*F) : 6 ～ 24inch (150 ～ 600mm )
Note 2: If the setting value for meter value is changed, the setting value by flow unit and the setting
value for exciting frequency of no concern may be rewritten.
After the meter size is set, be sure to check the setting values of Range, Count (Pulse) Rate
and Exciting Frequency.
Display example
Select A2: METER SIZE from the setting item selection.
The currently set meter size (50mm in this example) appears.
50 mm
The cursor appears.
50 mm
Change the set value for meter size to 100mm.
The set value for meter size can be changed using
100 mm
(Note 1)
The display blinks and the set value is displayed for
confirmation.
Press
100 mm
disappears and the display returns to the condition that the
setting value is displayed.
Returns to the menu of setting item selection.
In the case of the converter for large meter
size detector (LF232*B)
600mm
24inch
- 59 -
Description
again to write the data. Then the cursor
MENU/ENT
700mm
3000mm
28inch
120inch
6F8A0917
switch.
Advertisement
Table of Contents
