Extender Kit With Remote/Repeater Installation - Tripp Lite B126-1P0-WP-1 Owner's Manual

Extender Kit with Remote/Repeater Installation

Notes:
1) Test to make sure the entire installation works properly before pulling
cables through ceilings/walls.
2) To achieve maximum distance and performance, use 24 AWG solid
wire Cat5e/6 cable. Using stranded wire Cat5e/6 cable, or cable
with a gauge (AWG) size higher than 24 AWG, will result in shorter
extension distance. Higher gauge cabling, such as 26 AWG, has a
more limited transmission capability than lower gauge cabling. All
Tripp Lite N202-Series Cat6 cables are made with 24 AWG solid wire
cabling.
3) The B126-1A1 and B126-1A1-WP are set to transmit a stereo audio
signal by default. Press the Audio button on the local unit to switch to
7.1-channel surround-sound audio.
4) The installation diagram shows a B126-1A1 unit. The B126-1A1-WP
installation is the same, except there is no local monitor port.
OPTIONAL LOCAL
MONITOR
1
Make sure the HDMI source is powered OFF.
2
Connect the HDMI source to the INPUT port on the B126-1A1 or
B126-1A1-WP using a Tripp Lite P568-Series HDMI Cable.
201109206-93-3023-EN.indd 10
Up to 175 ft. at 1080i (60Hz)
Up to 125 ft. at 1080p (60Hz)
BLU-RAY
B126-1A1 LOCAL
TRANSMITTER
Up to 175 ft. at 1080i (60Hz)
Up to 125 ft. at 1080p (60Hz)
Up to 175 ft. at 1080i (60Hz)
Up to 125 ft. at 1080p (60Hz)
B126-110 REMOTE B126-110 REMOTE
REPEATER REPEATER
10
Up to 175 ft. at 1080i (60Hz)
Up to 125 ft. at 1080p (60Hz)
B126-1A1 REMOTE
RECEIVER
B126-110 REMOTE
REPEATER
10/24/2011 10:01:21 AM