Tripp Lite B126-1P0-WP-1 Owner's Manual page 21

1
2
3
4
5
6
7
8
9
10
11
201109206-93-3023-EN.indd 21
Extender/Splitter Daisy-Chain Installation
Make sure the HDMI source is powered OFF.
Connect the HDMI source to the INPUT port on the B126-004 using
a Tripp Lite P568-Series HDMI Cable.
Connect the LOCAL port on the B126-004 to the INPUT port on a
second B126-004 using the included 1-ft. HDMI daisy-chain cable.
Repeat step 3 if you want to connect a third B126-004.
Optional: Connect a local monitor to the LOCAL HDMI port of the
last B126-004 using a Tripp Lite P568-series HDMI cable.
Connect the external power supply to the first B126-004 in the
daisy-chain and plug it into a Tripp Lite Surge Suppressor, PDU or
UPS. The green RJ45 LEDs and the red Power LED on the B126-
004 will illuminate to indicate power is being received from the
external power supply.
Repeat step 6 for each additional B126-004 in the daisy-chain.
Using Cat5e/6 cable, connect one of the RJ45 output ports on the
local unit to the RJ45 input port on a B126-1P0, B126-1A0,
B126-1P0-WP-1 or B126-1A0-WP-1 remote unit.
Repeat step 8 for each additional remote unit you are connecting.
B126-1A0 and B126-1A0-WP-1 only: Connect the external power
supply to the B126-1A0 or B126-1A0-WP-1, and plug it into a Tripp
Lite Surge Suppressor, PDU or UPS. The green and orange LEDs
illuminate, with the green LED indicating the unit is receiving power
from the external power supply, and the orange LED indicating the
unit is connected to a powered ON local unit via Cat5e/6 cable.
Repeat step 10 for each additional B126-1A0 or B126-1A0-WP-1 in
the installation.
(B126-004 only)
21
10/24/2011 10:01:23 AM