Tripp Lite B126-1P0-WP-1 Owner's Manual page 17

1
2
3
4
5
6
7
Up to 4 units can be daisy-chained (3 remote/repeaters and 1 receiver).
To connect additional remote/repeater units, proceed to step 8. To finish
your installation with a B126-1A0 or B126-1A0-WP-1 remote receiver
unit, proceed to step 12.
8
9
201109206-93-3023-EN.indd 17
Extender/Splitter with Remote/Repeater Installation
Make sure the HDMI source is powered OFF.
Connect the HDMI source to the INPUT port on the B126-002 or
B126-004 using a Tripp Lite P568-Series HDMI Cable.
Optional for B126-004: Connect a local monitor to the LOCAL
HDMI port using a Tripp Lite P568-Series HDMI Cable.
Connect the external power supply to the local unit and plug it into
a Tripp Lite Surge Suppressor, PDU or UPS. The green RJ45 LEDs
illuminate to indicate power is being received from the external
power supply. An additional Red LED on the B126-004 also
illuminates to indicate that power is being received.
Using Cat5e/6 cable, connect one of the RJ45 output ports on the
local unit to the RJ45 input port on the B126-110 remote/repeater
unit.
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unit using a Tripp Lite P568-Series HDMI Cable.
Connect the external power supply to the remote/repeater unit and
plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The green
power LED and the Green RJ45 LEDs illuminate to indicate the unit
is receiving power.
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the first
remote/repeater unit to the RJ45 INPUT port on a second remote/
repeater unit.
Connect a monitor to the HDMI OUTPUT port on the remote/repeater
unit that you just added using a Tripp Lite P568-Series HDMI Cable.
17
10/24/2011 10:01:23 AM