Related Manuals for Tripp Lite B126-1A1SR
Summary of Contents for Tripp Lite B126-1A1SR
-
Page 1: Table Of Contents
Owner’s Manual HDMI + RS232 Serial and IR Control over Cat5 Extender Kit Model: B126-1A1SR Table of Contents Package Contents Optional Accessories Product Features Mounting Instructions Installation Instructions Warranty & Warranty Registration 1111 W. 35th Street, Chicago, IL 60609 USA www.tripplite.com/support... -
Page 2: Package Contents
Package Contents • Local Transmitter and Remote Receiver Units • Two sets of IR-IN Cables • Two sets of IR-OUT Cables • 3.5 mm Male-to-DB9-Female Adapter Cable • 3.5 mm Male-to-DB9-Male Adapter Cable • Two sets of External Power Supplies (Input: 100-240V, 50/60 Hz, 0.5A Output: 5V, 2A) •... -
Page 3: Product Features
Product Features • Transmits a 1080p (60 Hz) signal past the standard 16 ft. (5 m) distance limitation over a single Cat5e/6 cable • IR functionality allows you to use your HDMI source’s remote control in the same location as your extended monitor •... -
Page 4: Mounting Instructions
Mounting Instructions The B126-1A1SR comes with mounting hardware that allows it to be mounted in a variety of ways. The following images show the different ways the included mounting brackets can be attached for different mounting methods. Note: The photos below are of the B126-1A1 HDMI extender, but the mounting brackets can be attached to the B126-1A1SR in the same way. -
Page 5: Installation Instructions
Installation Instructions Note: Test to make sure the entire installation works properly before pulling cables through ceilings/walls. To achieve maximum distance and performance, use a 24Awg solid wire Cat5e/6 cable. Using a stranded wire Cat5e/6 cable, or a cable with a gauge size higher than 24Awg, will result in shorter extension distance. All Tripp Lite N202-Series Cat6 cables are made with 24Awg solid wire cabling. - Page 6 Installation Instructions Connect the RJ45 Output port on the local transmitter unit to the RJ45 Input port on the remote receiver unit using a Cat5e/6 cable. Connect the HDMI monitor to the HDMI Output port on the remote receiver unit. Connect the included 3.5 mm Male-to-DB9-Male adapter cable to the RS232 port on the remote receiver unit, and then connect the RS232 device to the adapter using a DB9 Serial cable.
-
Page 7: Warranty & Warranty Registration
Warranty & Warranty Registration 1-Year Limited Warranty TRIPP LITE warrants its products to be free from defects in materials and workmanship for a period of one (1) year from the date of initial purchase. TRIPP LITE’s obligation under this warranty is limited to repairing or replacing (at its sole option) any such defective products. - Page 8 1111 W. 35th Street, Chicago, IL 60609 USA www.tripplite.com/support 201201216 • 933163-EN 201201216-93-3163.indd 8 2/9/2012 9:15:40 AM...