Tripp Lite B126-1P0-WP-1 Owner's Manual page 14

Standard Extender/Splitter Installation
1
Make sure the HDMI source is powered OFF.
2
Connect the HDMI source to the INPUT port on the B126-002 or
B126-004 using a Tripp Lite P568-Series HDMI Cable.
3
Optional for B126-004: Connect an HDMI monitor to the LOCAL
port on the B126-004 using a Tripp Lite P568-Series HDMI Cable.
4
Connect the external power supply to the B126-002 or B126-004
local unit and plug it into a Tripp Lite Surge Suppressor, PDU or UPS.
The green RJ45 LEDs and the red Power LED on the B126-004, and
the green RJ45 LEDs on the B126-002, will illuminate to indicate
power is being received from the external power supply.
5
Using Cat5e/6 cable, connect one of the RJ45 output ports on the
local unit to the RJ45 input port on a B126-1P0, B126-1A0,
B126-1P0-WP-1 or B126-1A0-WP-1 remote unit.
6
Repeat step 5 for each additional remote unit you are connecting.
7
B126-1A0 and B126-1A0-WP-1 only: Connect the external power
supply to the B126-1A0 or B126-1A0-WP-1, and plug it into a
Tripp Lite Surge Suppressor, PDU or UPS. The green and orange
LEDs illuminate, with the green LED indicating the unit is receiving
power from the external power supply, and the orange LED indicating
the unit is connected to a powered ON local unit via Cat5e/6 cable.
8
Repeat step 7 for each additional B126-1A0 or B126-1A0-WP-1 in
the installation.
9
Connect the B126-1P0 HDMI connector to a monitor; or, connect
the B126-1P0-WP-1, B126-1A0 or B126-1A0-WP-1 to a monitor
using a Tripp Lite P568-Series HDMI Cable. Both the green and
orange RJ45 LEDs on the B126-1P0, and the green LED on the
B126-1P0-WP-1, illuminate to indicate the unit is receiving power
from the connected monitor.
201109206-93-3023-EN.indd 14
14
10/24/2011 10:01:21 AM