Valcom IP Solutions VIP-800 User Manual

NETWORKED PAGING ZONE EXTENDER
INTRODUCTION
The VIP-800 enables voice access to a single zone of
one-way paging over an IP-based LAN/WAN. This will
allow page zone extension anywhere on the network.

SPECIFICATIONS

Access Methods

• PBX (VIP-820 connected to a analog station port)
• VIP-810 plus POTS phone set
• 600 Ohm Supervised Page Port
• Any of Valcom's distributed amplified one-way
Page Controls (V-2003A, V-2006A,V-2924A)
Features
• RJ-45 for network connection
• Front panel activity LED
• Network activity LED's on RJ-45
• Provides audio for up to 150 Valcom one-way
amplified speaker assemblies
• Background music input
• Contact closure or VOX operation of input
• Removable screw terminal connectors provided
for both inputs and outputs
• Page with music output, music mutes during page
• Output control contact closure provided during
paging output
• May be used with 25 or 70 Volt amplifiers
• 2.5mm jack for DC power (115VAC TO 24VDC
adapter provided)
NOTE: Even after assigning a static ID address
the unit will not respond to a "Ping" test.
Dimensions/Weight
• 1.88" H x 5.50" W x 4.15" D
(4.78cm H x 13.97cm W x 10.54cm D)
• Weight: 0.55 lbs. (0.25 kg)
Nominal Specifications
Input Impedance:
Input Level:
Voice Switch Sensitivity:
Music Source Input Impedance:
Music Input Level:
Output Impedance:
Output Level:
Nominal Power Requirements
Voltage:
Current:
VIP-800
Environment
Temperature:
Humidity:
INSTALLATION
NOTE: The telephone system referred to in this
manual is the customer premise equipment such
as an electronic key system, a PBX or a dedicated
single line telephone(s). The VIP-800 is not
intended for direct or indirect connection to the
public telephone network. When used with a
customer premise telephone system such as a
key system or PBX system, these units are
interfaced to the system via a fully protected page
port or system central office port, which is a fully
protected interface device. Also, the host system
must be configured to disallow central office
trunk conferencing in order to prevent indirect
connection to the public network.
600 Ohms
-10dBm nominal
-21dBm
8 to 600 Ohms
Mounting
-10dBm nominal
The VIP-800 was designed for wall or table mounting.
8 Ohms
Secure unit to wall studs or a suitable brace away
- 10dBm nominal
from heat sources or strong magnetic fields (motors,
fans, power supplies, etc.) with the control and
terminal strip accessible. One wood screw is included
24VDC
for mounting.
325mA
1
0 to 85% non-precipitating
Precautionary Designations
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified service personnel.
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
ISSUE 3
0 to +40 Degrees C
947051