Model Ut60 G: Temperature Measurement - UNI-T UT60F Operating Manual

Measurement Operation(13)
I. Model UT60 G: Temperature Measurement
(see figure 11)
( figure 11)
Warning
To avoid harms to you, please do not attempt to
measure voltages higher than 60V DC or 30V rms AC.
The temperature measurement range is -40
To measure temperature, connect the Meter as follows:
1. Insert the red temperature probe into the mA
and the black temperature probe into the COM terminal.
2. Set the rotary switch to
3. Place the temperature probe to the object being
measured.
The measured value shows on the display.
Note
l The Meter automatically displays the temperature
value inside the Meter when there is no temperature
probe connection.
l The included point contact temperature probe can
only be used up to 250
higher than that, the other type temperature probe
must be used instead.
l When temperature measurement has been completed,
disconnect the connection between the temperature
probe and the circuit under test, and remove the
temperature probe away from the input terminals of
the Meter.
Model UT60F/G: OPERATING MANUAL
o
C;
o
C. For any measurement
29
o o
C~1000 C.
o
C terminal