UNI-T UT60F Operating Manual page 28

Model UT60F/G: OPERATING MANUAL
Measurement Operation(12)
The measurement ranges are:
Model UT60F: 4kHz, 40kHz, 400kHz, 4MHz and
Model UT60G: 6kHz, 60kHz, 600kHz, 6MHz and
To measure frequency, connect the Meter as follows:
1. Insert the red test lead into the HzV terminal
and the black test lead into the COM terminal.
2. Set the rotary switch to Hz;
3. Connect the test leads across with the object
being measured.
The measured value shows on the display.
Note
l When measuring input scope < 30V rms
frequency signal, follow the above procedure.
When measuring input scope >30V rms,
reading may not be obtained due to the
fluctuation of overload protection circuit.
l The test lead has distributed capacitors
during measurement, it has more attenuate
effect against high frequency. Therefore,
when testing higher than 1MHz frequency
signal, it is recommended to use a high and
as short as possible frequency transmit cable
carrying out the testing.
l When Hz measurement has been completed,
disconnect the connection between the testing
leads and the circuit under test and remove
the testing leads away from the input terminals.
40MHz.
60MHz.
28