Dc Or Ac Current Measurement - UNI-T UT60F Operating Manual

Measurement Operation(3)
2. Set the rotary switch to V
to select AC measurement mode.
3. Connect the test leads across with the object being
measured.
The measured value shows on the display.
Note
l In each range, the Meter has an input impedance of
10M . This loading effect can cause measurement
errors in high impedance circuits. If the circuit
impedance is less than or equal to 10k , the error is
negligible (0.1 or less).
l When AC voltage measurement has been completed,
disconnect the connection between the testing leads
and the circuit under test and remove testing leads
from the input terminals.
C.

DC or AC Current Measurement

( figure 5)
Warning
If the fuse burns out during measurement, the Meter
may be damaged or the operator himself may be hurt.
Use proper terminals, function and range for the
measurement. When the testing leads are connected
to the current terminals, do not parallel them across
any circuit.
Model UT60F/G: OPERATING MANUAL
;
and press BLUE button
Select
DC or AC
black
19
(see figure 5)
red