Brother NV4500D Operation Manual page 125

f f f f
Set the presser foot in the 3 mm (approx.
1/8 inch) margin.
g g
g g
Starting from the end of the zipper opening,
sew to a point about 50 mm (approx.
2 inches) from the edge of the fabric, then
stop the machine.
h h
h h
Pull down the zipper slider, then continue
sewing to the edge of the fabric.
a
a 50 mm (approx. 2 inches)
b 3 mm (approx. 1/8 inch)
CAUTION
Make sure the needle does not strike the zipper
during sewing. If the needle strikes the zipper, the
needle may break, leading to injury.
i i i i
Close the zipper, turn the fabric over, and
sew a basting stitch.
a
d
a Front of the skirt (wrong side of fabric)
b Basting stitches
c Front of the skirt (right side of fabric)
d Back of the skirt (right side of fabric)
j j j j
b
k k
k k
l l
l l
m m m m
n n n n
b
c
SEWING THE STITCHES
Remove the presser foot, and reattach it so
that the left side of the pin is attached to the
presser foot holder.
* When sewing the left side of the zipper, the needle
should drop on the right side of the presser foot.
When sewing the right side of the zipper, the needle
should drop on the left side of the presser foot.
c
a
b
a Right
b Left
c Needle drop position
Set the fabric so that the left edge of the
presser foot touches the edge of the zipper
teeth.
Sew reverse stitches at the top of the
zipper, then continue sewing.
Stop sewing about 50 mm (approx.
2 inches) from the edge of the fabric, leave
the needle in the fabric, and remove the
basting stitches.
Open the zipper and sew the rest of the
seam.
a
b
c
d
a Basting stitches
b 7 to 10 mm (approx. 1/4 inch to 3/8 inch)
c Reverse stitches
d 50 mm (approx. 2 inches)
3
113