I Inserting The Fabric - Brother NV4500D Operation Manual

I Inserting the Fabric

Note
• If the fabric is placed loose in the embroidery
frame, the embroidery design will sew out
poorly. Insert the fabric on a level surface,
and gently stretch the fabric taut in the
frame. Follow the steps below to insert the
fabric correctly.
a a
a a
Lift-up and loosen the frame adjustment
screw and remove the inner frame.
a Frame adjustment screw
b Inner frame
b b
b b
Lay the fabric right side up on top of the
outer frame.
Re-insert the inner frame making sure to
align the inner frame's
frame's .
a
b
a Inner frame
b Outer frame
c Frame adjustment screw
b
a
with the outer
c
c c c c
Slightly tighten the frame adjustment screw,
and then remove the slack in the fabric by
pulling on the edges and corners. Do not
loosen the screw.
Memo
When using the extra large frame, tighten the
adjustment screws at the top and bottom of
the frame, so that the spaces at the top and
bottom of the frame are equal.
d d d d
Gently stretch the fabric taut, and tighten
the frame adjustment screw to keep the
fabric from loosening after stretching.
* After stretching the fabric, make sure the fabric is
taut.
* Make sure the inside and outside frames are even
before you start embroidering.
a
a Outer frame
b Inner frame
c Fabric
Memo
Stretch the fabric from all four corners and all
four edges. While stretching the fabric, tighten
the frame adjustment screw.
PREPARING THE FABRIC
b
c
5
159