Advertisement
BIPAC-74x Series Router – 741 GE, 741 GE V2.0 and 743 GE
Both the user's Operating System and the relevant application must support UPnP in
addition to the router. Windows XP and Windows Me natively support UPnP (when the
component is installed), and Windows 98 users may install the Internet Connection
Sharing client from Windows XP in order to support UPnP. Windows 2000 does not
support UPnP.
Disable: Check to disable the router's UPnP functionality.
Enable: Check to enable the router's UPnP functionality.
UPnP Port: Its default setting is 2800. It is highly recommended for users to use this port
value. If this value conflicts with other ports already being used you may wish to change
the port.
SNMP Access Control (Software on a PC within the LAN is required in order to utilize this
function) – Simple Network Management Protocol.
Read Community: Specify a name to be identified as the Read Community, and an IP
address.
This community string will be checked against the string entered in the
configuration file. Once the string name is matched, user obtains this IP address will be
able to view the data.
Write Community: Specify a name to be identified as the Write Community, and an IP
address. This community string will be checked against the string entered in the
configuration file. Once the string name is matched, users from this IP address will be able
to view and modify the data.
Trap Community: Specify a name to be identified as the Trap Community, and an IP
address. This community string will be checked against the string entered in the
configuration file. Once the string name is matched, users from this IP address will be
sent SNMP Traps.
SNMP Version : SNMPv2c
Billion provides an SNMP utility for download via the website at
allows users to obtain information from the router without the need to have advanced
knowledge of the workings of SNMP. Advanced users may refer to the information below in
order to access the router using custom utilities and scripts:
SNMP version: SNMPv2c
(SNMPv2c is the combination of the enhanced protocol features of SNMPv2 without the
SNMPv2 security. The "c" comes from the fact that SNMPv2c uses the SNMPv1
community string paradigm for "security", but is widely accepted as the SNMPv2 standard.)
Traps supported: Cold Start, Authentication Failure.
The following MIBs are supported:
From RFC 1213 (MIB-II):
Chapter 3: Basic Installation and Configuration
System group
www.billion.com.au
which
96
Advertisement
