Using The Battery; Connection For The Cigarette Lighter - Becker Traffic Assist Z 107 Operating Instructions Manual

Using the battery

The internal power supply is via the inte-
grated rechargeable battery. The recharge-
able battery is maintenance-free and does
not require any particular care.
Note:
Note that if the battery is completely dis-
charged, it may take up to a minute be-
fore the device can be switched on again.
Note:
In the event of a defective battery, please
contact your authorised dealer. Please do
not attempt to remove the battery your-
self.
Connection for the cigarette
lighter
Note:
If the cigarette lighter has recently been
used and is still hot, wait until the lighter
socket has cooled down.
Connect the power supply via the vehicle
battery and the cable provided for the cig-
arette lighter as follows:
> Hold the USB socket at the corrugated
grip area and push it into the connect-
ing socket on the Traffic Assist or into
the connecting socket on the carrier
plate as far as the stop, without using ex-
cessive force.
GENERAL OPERATION
> Insert the adapter into the cigarette
lighter.
Note:
When the engine is switched off, the
power supply slowly discharges the vehi-
cle battery via the cigarette lighter!
Do not therefore operate the Traffic As-
sist for long periods with the engine
switched off.
Note:
The TMC messages are received via the
cable for the cigarette lighter. Messages
can therefore only be received if the cable
is connected.
>>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
17