Table of Contents
Advertisement
Installation Procedures
Follow these steps to install an external antenna and connect it to the
Access Point 530.
C a u t i o n
Never mount the access point outdoors to be near an external antenna. The
access point must always be installed indoors.
1. Plan the Installation
■
■
W a r n i n g
The radiated output power of this device is below the FCC radio exposure
limits. Nevertheless, the device should be used in such a manner that the
potential for human contact during normal operation is minimized. To avoid
the possibility of exceeding the FCC radio frequency exposure limits, human
proximity to the antennas should not be less than 25 cm (10 inches) during
normal operation.
■
Pigtail Cables - Use the coax pigtail cable attached to the antenna to
connect to the access point. Because most pigtail cables are a relatively
short length (83 cm or 33 inches), be sure to find a suitable mounting
position for the antenna that is not too far from the access point. If an
extension cable is required, please contact a professional installer who is
trained in RF installation and knowledgeable in the local regulations.
Installation Location - Plan the antenna's position and orientation.
Consider these points:
•
Use the antenna's mounting bracket or other hardware, if included.
•
For optimum performance, mount antennas as high as possible above
any obstructions, and away from any signal absorbing or reflecting
structures (such as those containing metal)
•
Be sure there are no other radio antennas mounted within 2 m (6 ft).
•
Consider the antenna's radio coverage pattern so that it can properly
cover the intended service area.
Omnidirectional Antennas - Consider these factors when selecting a
location for these antennas:
•
Always mount the antenna in a vertical orientation so that the radio
coverage pattern fills the intended horizontal space.
Using an External Antenna with the Access Point 530
Installation Procedures
4-3
Hide quick links:
Advertisement
Table of Contents
