HP ProCurve Wireless Access Point 530 Installation And Getting Started Manual page 48

Getting Started With Access Point Configuration
1.
2.
3.
4.
3-6
From any command level, type the show radio command followed by the
radio number to display the radio's configuration, including the radio
mode, radio channel, and operation status. The following illustration
shows the default settings.
ProCurve Access Point 530# show radio 1
Description Radio 1 - 802.11g
Base MAC 00:14:C2:A5:3C:00
Mode 802.11g
Channel 1
Preamble long
Slot-time short
TX-Power(dBm) 0
Antenna Mode diversity
RTS-Threshold 2347
WMM QoS Enabled
Max Stations 256
Rate-Limiting (Disabled)
Rate-Limit(packets/second)
AP-Detection (Disabled)
Periodic Scan Duration(ms)
List Max Entries
ProCurve Access Point 530#
Type configure to enter global configuration mode, and then type radio 1
to access the wireless interface-configuration mode for radio 1.
ProCurve Access Point 530#configure
ProCurve Access Point 530(config)#radio 1
ProCurve Access Point 530(radio1)#
Set the channel through which the access point's radio 1 (802.11b/g)
communicates with its wireless stations. The default setting is to statically
set the operating channel number. Type channel-policy static channel,
where channel can be from 1 to 14, depending on the wireless regulations
specified by your country. Otherwise, type channel-policy auto to have the
access point automatically select the least congested channel.
ProCurve Access Point 530(radio1)#channel-policy static 11
ProCurve Access Point 530(radio1)#
To set the primary Service Set Identifier (SSID) for the access point. Type
wlan 1 to enter SSID interface configuration for the primary SSID inter-
face. Then type ssid identifier, where identifier can consist of up to 32
alphanumeric characters and is case sensitive.
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)# ssid AP530
ProCurve Access Point 530(radio1-wlan1)#
Status
Channel-Policy
WLANs Supported
CTS Protection
Beacon-Interval(K-us)
Power Reduction(dB)
Antenna(s) In Use
Fragment-Threshold
Inactivity Timeout
50 Burst-Limit(packets/second)
30 Periodic Scan Interval(sec)
255 List Expiration Time(sec)
Disabled
Auto
16
Enabled
100
0
internal
2346
1800
75
10
3600