HP ProCurve Wireless Access Point 530 Installation And Getting Started Manual page 67

Table of Contents

Advertisement

Tip
Problem
Try the following procedures:
5
The
10/100Base-TX
• Verify that both ends of the cabling, at the access point and the connected device, are
network
connection is not
• Verify the connected device and access point are both powered on and operating
working
properly.
• Verify duplex operation (see page 5-1).
• If these procedures don't resolve the problem, try using a different cable.
6
The port may be
VLAN configuration may affect the port operation. Use the access point's console to see
improperly
how the port is configured for VLANs.
configured.
Make sure also, that the device at the other end of the connection is indicating a good
link to the access point. If it is not, the problem may be with the cabling between the
devices or the connectors on the cable.
connected properly.
correctly.
Diagnosing with the LEDs
Solution
Troubleshooting
5-5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 530

Table of Contents