HP ProCurve Wireless Access Point 530 Installation And Getting Started Manual page 50

Getting Started With Access Point Configuration
Here is some information on the basic IP address and wireless configuration
parameters. For more information on these parameters, see the Management
and Configuration Guide.
Parameter Default
Username admin
Password admin
IP Address 192.168.1.10
Subnet Mask 255.255.255.0
Default Gateway not set
Radio 1 Mode 802.11g
Radio 2 Mode 802.11a
SSID Radio 1 - SSID 1
Radio 2 - SSID 2
Channel Policy Auto
Wireless Operation Enabled
Note: The IP address and subnet mask assigned for the access point must be compatible with the IP addressing used
in your network. For more information on IP addressing, see the Management and Configuration Guide.
3-8
The name of the manager.
The password for the manager.
IP address compatible with your network.
Subnet mask compatible with your network.
IP address of the next-hop gateway node for network traffic that needs to
be able to reach off-subnet destinations.
The operating mode for Radio 1.
The operating mode for Radio 2.
The Service Set Identifier (SSID) for the access point interface, which is
broadcast in the beacon frames.
The radio channel through which an access point radio communicates
with its wireless stations. When attempting to connect, most wireless
stations automatically set their radio channel to the same channel used
by the access point.
Wireless operation is automatically enabled after you have set the country
code.