Usb Connector Module - HP ProBook 4710s Maintenance And Service Manual

USB connector module

Description
Cable Kit
Before removing the USB connector module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a.
b.
c.
d.
e.
f.
g.
h.
i.
Remove the USB connector module:
1. Disconnect the USB cable from the system board (1).
2. Lift up the USB cable from the routing channels in the base enclosure (2).
3. Remove the short Phillips PM2.5×3.0 screw (3) and the long Phillips PM2.5×9.0 screw (4) that
secure the USB connector module to the base enclosure.
70 Chapter 4 Removal and replacement procedures
Battery on page
Switch cover and keyboard (see
Memory module (see Memory module on page
Optical drive (see Optical drive on page
Speakers (see Speakers on page
Palm rest (see Palm rest on page
WLAN module (see WLAN module on page
Hard drive (see Hard drive on page
Display assembly (see
Top Cover (see Top cover on page
Spare part number
535757-001
41).
Switch cover and keyboard on page
47)
49)
50)
55)
52)
Display assembly on page
65)
42)
45)
59)