h.
Display assembly (see
i.
Top Cover (see
j.
Heat sink and fan (see
Remove the RJ-45 (network) jack:
1.
Disconnect the RJ-45 (network) cable from the system board (1) and remove the tape (2) that
secures the cable to the base enclosure.
2.
Lift the RJ-45 (network) jack (3) straight up from the retention clips to remove it.
Reverse this procedure to install the RJ-45 (network) jack.
Display assembly on page
Top cover on page
65)
Heat sink and fan on page
59)
74)
Component replacement procedures
77