Usb Connector Assembly - HP ProBook 4525s Maintenance And Service Manual

8. Remove the screw (1) that secures the USB to the computer, disconnect the cable (2) from the
system board and then, remove the device (3) from the computer.
Reverse this procedure to install the system board.

USB connector assembly

The USB connector assembly is included in the Cable Kit, spare part number 613224-001 for
computers with 15.6-in displays.
Before removing the USB connector assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the switch cover and keyboard (see
6. Remove the optical drive (see
7. Remove the power button board cable (see
8. Remove the speakers (see
9. Remove the thermal shield (see
94 Chapter 4 Removal and replacement procedures
Battery on page 48).
Switch cover and keyboard on page
Optical drive on page
Power button board on page
Speakers on page 58).
Thermal shield on page
54).
56).
59).
49).