Axminster AW10BSB2 User Manual page 26

Setting the Machine
Fig 92
Main table height adjusting bolt, one to
each corner of the table
Fig 93
'Jack' the table up by screwing both the
height adjusting bolts UP approximately
3/4 turn.
Fig 91
Set the sliding table so that the front edge is
inline with the front edge of the saw table. Place
a long straight edge (a bit more than twice the
width of the sliding table) along the front edges
of the two tables. Set the near corner of the table
to the straight edge.
Move the table and the straight edge to the rear
of the MAIN table. Set the rear corner to the
straight edge. Adjust the table to bring it level
under the straight edge. Move the table and the
straight edge back to the front of the main table
and check the table is level; adjust if necessary.
Once you are satisfied, and all the bolts are now
'nipped', slide the table back and forth and check
the gap between the sliding table and the main
table.
It should be approximately 2-3mm and uniform
alongside the main table. Adjust as necessary,
making uniform adjustments of the bolts in each
bracket. Again, when you are satisfied; jack the
table up by screwing both the height adjusting
bolts up approximately
This will raise the table by something less than a
millimetre and will reduce the drag of the
workpiece at the main table edge, giving easier,
more controllable movement. Check all bolts are
tightened up, recheck all your settings.
26
/ turn (See figs 92-93).
3
4