Table of Contents
Advertisement
Introduce the slot in the riving knife (14) over the two centre line bolts, behind the washers and
nip the bolts to just hold the riving knife against the mounting plate. Set the riving knife so it is
close to the blade, (gap about 2-3mm if possible). Tighten the clamping bolts securely. (See figs 23-
24) Replace the saw gullet.
Fig 23
14
Locate the saw hood guard (13), the 30mm extraction hose (17) and the 50mm jubilee clips (16).
There are two fastenings in the guard, a Phillips screw/nut at the rear and a coach bolt/knob just in
front of it. Introduce the phillips screw into the 'L' shaped slot in the riving knife and push it down
and back so the screw is locked into the slot. Lower the guard so the clamping bolt fits into the
curved slot in the riving knife. (See fig 25-26) Tighten the clamping knob to pinch the guard to the
riving knife and hold it in position. (See fig 27)
'L' shaped slot
Fig 25
Fig 27
Clamping knob
Push the jubilee clips (16) over the ends of the hose (17), push the hose onto the dust extraction
outlet on the guard and the main dust extraction moulding (4) and tighten the clips to hold it in
place. (See figs 28-29)
2.3mm gap
Curved slot
13
Mounting plate
13
Initial Assembly
Fig 24
Fig 26
Fig 28
17
16
Hide quick links:
Advertisement
Table of Contents
