Table of Contents
Advertisement
Locate the capping plates for the front rail (24D) and using the self tapping screws (24E), securein
place. (See fig 35) Set the front rail in position, remembering that it must be slightly inside the
front left hand edge of the main saw table, so that the sliding table does not collide with it.
Tighten ONLY the 3 bolts in the main saw table. Repeat the process for the back rail.
Capping plate
Fig 35
Locate the Rip Fence assembly (20), fit the rip fence assembly to the saw by ensuring the
clamping lug at the rear of the fence is hooked over the back rail (23), lower the fence and
manoeuvre the bracket over the front guide rail (22). (See fig 36)
Micro-Adjuster Assembly
Locate the Micro-Adjustor (25) there are two Phillips screws through the adjustor
mounting bracket with square nuts on them. Ensure the nuts are undone sufficiently to allow
them to slide into the channel in the Rip Fence mounting bracket, position as required, normally
slightly to the right of the rip fence, (See figs 37-38) and tighten the screws securely.
Fig 37
25
Locate the capping plates for the Rip Fence Mounting Bracket (24C) and fit carefully using the self
tapping screws. (See figs 39-40)
Fig 39
24C
Tighten the Phillips screws securely
15
Initial Assembly
20
Fig 36
22
Fig 38
Fig 40
Hide quick links:
Advertisement
Table of Contents
