Specification - Axminster ZX25M User Manual

k) Swing the guard into position in front of the tool. The rising cam should have raised the
roller plunger of the interlock microswitch. If this is not the case, reposition the rising cam
so that this is so. (See fig 8)
l) Check that all loose tooling etc., has been removed from the work table. Check the tool is
firmly mounted in the quill, the chuck, et al, or remove all tooling, chuck etc. completely.
m) Raise the drive belt top cover. Plug the cable into the connecting socket and into the
mains supply. Check that there is nothing to foul the tool if the machine were to be started.
'Unclip' the safety cover of the switch. Press the start button, check the machine does not
start. Lower the drive belt cover and clip shut. Give the machine a 'quick burst' (Pressing
the start and stop buttons) Check the machine started and stopped as required, check
nothing untoward occurred, e.g. bad vibration, belt slippage, etc. If you are satisfied, start
the machine, allow it to run for a few seconds, then swing the guard out of position. Check
the machine stops. Reposition the guard and start the machine again. 'Slap' the switch
cover closed, (acts as an emergency stop), check the machine stops. (a moulded portion of
the switch cover depresses the stop button). If all the above checks where satisfactory, your
mill is ready for use. Enjoy.
Axminster No.
Rating:
Power Supply:
Motor:
Maximum Drilling Capacity:
Maximum Swing:
Maximum Distance Spindle Nose to Table:
Spindle Speeds:
Spindle Taper:
Diameter of Spindle Sleeve:
Max Spindle Travel:
Angle of Head Swivel:
Column Diameter:
Table Size:
Longitudinal Table Travel:
Transverse Table Travel:
Weight:
Footprint L X W X H:
Initial Check List (Continued)...
12 No.
Specification...
990123
ZX25M
Trade
240v a.c. 50Hz
750W
25mm
404mm
380mm
90-2150rpm
MT-3
62mm
100mm
360˚
92mm
585 x190mm
370mm
160mm
220kg
1320 X 900 X 960mm
700093
ZX30M
Trade
240v a.c. 50Hz
1.5kW
32mm
405mm
475mm
100-2080rpm
MT-3
75mm
130mm
360˚
115mm
730 x 210mm
175mm
500mm
270kg
1095 X 1010 X 1125mm
W
A X M I N S T E R
W H I T E
07