What's In The Box - Axminster ZX25M User Manual

Model Numbers:
1 No.
Box
1 No.
1 No.
3 No.
1 No.
4 No.
1 No.
1 No.
1 No.
1 No.
1 No.
1 No.
1 No.
1 No.
1 No.
2 No.
1 No. Guarantee Card 1 No. Instruction Manual
!
WARNING.
seek help or the use of some form of lifting device, (hoist, engine crane etc., ) before
you attempt to lift or move this machine.
Having unpacked your machine and its accessories, please check the contents against the
equipment list "What's in the box", if there are any discrepancies, please contact Axminster
Power Tool Centre using the procedures laid down in the catalogue. Please dispose of the
packaging responsibly, much of the material is bio-degradable. The machine and its
accessories will arrive coated with heavy corrosion preventative grease. This will need to be
cleaned from the machine, its components and accessories prior to it being set up and
commissioned. Use coal oil, paraffin or a proprietary degreaser to remove the barrier grease.
Be warned, it will stain if you splash it on clothing etc., wear overalls, coverall et al., rubber
gloves are also a good idea, as is eye protection if your cleaning process tends to be a little
bit enthusiastic. After cleaning, lightly coat the exposed metal surfaces of the machine with a
thin layer of light machine oil. N.B If you used paraffin/kerosene make sure you apply this thin
film sooner rather than later.
!
Please read the Instruction Manual prior to using your new machine; as well
as the installation procedure, there are daily and periodic maintenance
recommendations to help you keep your machine on top line and prolong its life.
Keep this Instruction Manual readily accessible for any others who may also be
required to use the machine.
Vertical Mill/Drill
Drill Chuck with Chuck Key
No. 3 MT /R8 Mounting arbor for Drill Chuck
125mm Wheel handles
100mm Wheel Handle
(3+1)Rod Handles (detached for packing)
Double Open Ended Spanner 17mm A/F x 19mm A/F
Allen Key 4mm
Allen Key 5mm
Allen Key 6mm
Allen Key 8mm
Break Taper Drift
Main Tool Post Cap
Drive Belt Cover Infill Cover
Draw Bar Nut Cover
Draw Bars (Stowed in Drive Belt Compartment)
1No. x M10, 1No. x
The ZX 25 Mill is a heavy piece of equipment. You are advised to

What's in the Box...

3
/ " Whitworth (NOT ZX30M M10 ONLY)
8
ZX-25M & ZX-30M
W
A X M I N S T E R
W H I T E
03